Home centers sell rolls of 6 in.
Do i need drip edge with gutters.
One of the most overlooked pieces of a new roofing system is the drip edge at both the rake and the eaves.
While drip edge is a common component in some areas of the country most atlanta roofers don t offer it because it s not part of most municipalities building code with dunwoody being an exception.
Water stains dirt debris and dripping water behind a gutter are usually the result of poorly installed or missing drip edge.
When you choose a reliable roofing contractor you can feel confident that you are getting the work done right the first time.
On the other hand installing a gutter apron on the existing roof is not possible.
A drip edge can be easily installed and there will be no need of lifting the shingles.
Once the apron s in place fasten it with sheet metal screws.
If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap.
The lower edge of a roof should extend beyond the fascia board by about 3 4 inch so that runoff drains into the gutters.
We have to cut our gutters apart to get them off now and we can t install the same gutter at the same height as you can access the screw under the drip edge.
This will not leave a very nice cut.
Does my roof need drip edge.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Drip edges are metal sheets usually shaped like an l installed at the edge of the roof.
Drip edge is a roof flashing that is installed at the leading edge of your shingle near the gutter it generally is a 1 x 3 or 1 x 2 piece of metal flashing slipped under the roofing material and over the top of the paper felting underneath the roofing shingles that hangs down into the gutter approximately 1.
If this slight overhang is too short water will drip behind the gutters leading to rotted roof sheathing and fascia stained siding and even soil erosion and a flooded basement.
Most premade drip edge flashin.
Do you have any suggestions.
As it will require you to lift the shingles which are just not possible.