Do I Use Screws Or Nails To Repair Siding

Temperature changes can cause some siding to expand and contract so leave a little room between the head and siding to compensate for this movement.

Do i use screws or nails to repair siding.

These grip rite 1 1 2 in. Nails are also called upon when securing plywood. From end and between 3 4 in. Vinyl siding tends to expand and contract considerably with temperature changes.

The problem should be easy to diagnose. Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1. Screw heads need to be sunk in enough so that they can be covered with a protective compound and painted over making them disappear. Nails are generally made of steel that can rust and corrode causing loss of integrity and staining of the installed product.

They are good for installing aluminum or vinyl siding. Make sure that your screw not only penetrates the siding but that it finds one of those studs. A few of the vinyl fasteners that are recommended are also the same as those used for aluminum siding. A professional grade screw gun for decks work well in applying the t1 11 to the studs.

Screws used for vinyl can be corrosion proof stainless steel or another corrosion proof material. Nails are often preferred for structural joining including framing walls because they are more flexible under pressure whereas screws can snap. Whether nails or screws it is important to use galvanized or stainless steel fasteners and then caulk them afterward. Pinning of the butt joints is not intended to increase wind load values.

Consider drilling pilot holes before driving exterior wood screws deck screws or nails especially when driving close to the edge of the wood. Aluminum siding nails 1 these grip rite 1 1 2 in. Aluminum siding nails 1 lb pack feature a large head and thin smooth shank that helps to reduce wood splitting. Even though they are more visible than finish nails you need common nails which have heads to prevent the siding from backing off the wall when it gets wet and begins to warp.

Do not screw in those areas of the wall where studs are not present. Pinning the plank down at the bottom edge is a common practice called pin back it is used to correct high nailing loose planks gaps or rattling.